=============================================================== FROM A MAN THAT BOUGHT AND INSTALLED HIS PARTS
Just put the TI-MAT in the 329, went in - no sweat - even with my 74 year old arthritic fingers. Just ordered ORD-BLK- for the 329 Night Guard - (NG) Thank you for a heck of a nice product! "
IF YOU LOST YOUR FACTORY SPRING OR SHOT IT ACROSS THE ROOM
EMAIL ME I HAVE SPRINGS THAT WILL WORK IN ALL FRAMES. FACTORY SPRING CALCULATES AT 30INLBS THE SPRINGS I HAVE ARE A BIT LARGER AND STRONGER AT 36INLBS. SPRINGS ARE 7 EACH
YOU CAN THROW A TOWEL OR RAG OVER TOP OF YOU HANDS. YOU CAN DO IT IN A DRYCLEANING BAG OR SOMETHING WHILE COMPRESSING SPRINGS TO KEEP THEM FROM FLYING IF YOU NEED TO. LOOK CLOSE AT HOW I HOLD THE SMALL ROD I USE TO COMPRESS SPRINGS IT'S HELD CLEAR OUT CLOSE TO THE END THIS KEEPS IT FROM DEFLECTING AND SLIPPING WHICH WILL CAUSE YOUR SPRING TO TAKE FLIGHT.
INSTALL NOTE from J.D.
When you put your parts in, once they are in and the Retainer is snapped in place just push on the Slug from the back side to flush it with the outside of the frame. It will stay there held by spring tension. That's how I install mine IN MY CARRY GUN. There's only a couple thousandths tolerance between the milled retainer channel and the thickness of my retainer. Had to be that way to make sure it would clear in all frames and won't bind when you compress the retainer and spring to get them to snap into the Slug. also won't bind if you're pullin the Lock Delete out and puttin it back in to do a detail cleaning after shootin when there's crud in the retainer channel. If I made the Slug any taller it would stick out of the frame when you push on the back from the inside. When I engineered this part set I also reduced the heel of the Slug to make sure it can't get in the way of the hammer. This was all done before I released my Lock Delete kit FOR EVERYONE TO BUY.
Honesty, commitment and quality